High Quality Stearic Acid Amide Emulsion

Stearic Acid Amide Emulsion:
Stearic acidamide amide, a white emulsion is not toxic, polluting, hazardous, or harmful to the environment. The product can be easily dispersed in water, has low viscosity and is highly dispersible.
Stearamide may also be known as stearamide. Its chemical composition is C17H35CONH2. Stearic acidamideamide is insoluble when mixed with water. It can be slightly soluble at room temperature in organic solvents. It is able to improve dispersion effects and the affinity of dyes.
Excellent adhesion and lubricity. No moisture absorption. You can mix it with paraffin wax. Ammonium salt is created by the reaction between stearic and ammonia. It then gets dehydrated to get the final product. It is a good, smooth product that has low hygroscopicity. Use it as a pigment ink mixed agent, surface-active and fiber oil agent.
The use of stearamide in thermal paper coatings can serve as both a sensor and slip agent, and as an anti-blocking and slip agent for polyolefin films. The base of stearates is fatty saturated linear monocarboxylic oils derived from natural vegetable oil. Send an inquiry for the most current price to purchase bulk Stearic Acid Amide Emulsion.

Technical Information of Stearic Acid Amide Emulsion:

How does Stearic Acid Amide Emulsion get made?
Insoluble in water, stearic Acid amide must be prepared using emulsifiers. Even after adding dispersant, water-based stearic Acid amide emulsion is still not able to disperse well. Additionally, it can easily precipitate. Long-term storage may result in flocculation. Additionally, high-speed stirring is required and grinding is done under heat to make the aqueous chemical stearic acids amide. The production process can be complicated.

First, add the water-based water-basedstearic Acid amide to the water. Next stir for 60 minutes at 2500r/min. Then add defoamer (stirring frequency is 2500r/min). Finally add the preservative. After stirring for 40 min stir again (stirring velocity is 2500r/min) and you will get an aqueous solution of stearic. This prepared water-based, stearic-acid amide-amide emulsion contains 41.7% solids and has a viscosity reading of 146mPa*S. After 30 minutes of centrifugation at 20000r/min, the water-based, stearic-acid amide-amide emulsion was left at 2035°C for 3 months. There were no flocculation or delamination.

Stearic Acid Amide Emulsion:
Stearamide can be used to lubricate and release molds for polyvinylchloride, polystyrene, and other plastics.
As an antiblocking agent to polyolefin film films, stearamide should be combined with oleamide-erucamide.
Stearamide, unlike the common inorganic anti-blocking agents (silica), does not affect the transparency. Stearamide is used to release synthetic rubber, natural rubber, and as a lubricant for rubber compounds. This gives the product a high Gloss.
The sensitizer of thermal paper is made from stearic Acid amide Ultrafine Aqueous Dispersion.
The ultra-fine, water-based, stearic Acid amide dispersion serves as textile waterproofing, fabric softener and antistatic agent. It also acts as a wetting agent.